Product introduction of automotive cable clamp positioning parts
The automotive cable clamp positioning part is a "invisible order maintainer" in the automotive circuit system. It was specially designed to solve the problems of cable clutter and displacement, so that every bunch of cables can work stably on the established trajectory.
In terms of material selection, it fully takes into account the complex working conditions of the car. The main body is made of high-strength PA66 nylon, which has both toughness and hardness. It is not deformed after environmental tests of -40℃ to 120℃, and can withstand the high temperature of the engine compartment, the low temperature of the chassis and the continuous impact caused by body vibration. The reinforced material used in some special parts is also added with glass fiber, which increases the tensile strength by 40%. Even if it bears the gravity of the cable for a long time, it will not break or loose.
In terms of adaptability, it covers a variety of specifications and scenarios of automotive cables. From small signal lines with a diameter of 2mm to high-voltage cable bundles of 30mm, the corresponding positioning parts can be found - the narrow-mouth model accurately locks the single-strand cable to prevent it from rubbing with other components during bumps; the wide-mouth multi-slot model can fix multiple bundles of cables at the same time, allowing the wiring harnesses in the engine compartment to be arranged neatly like "arranged soldiers" to avoid the risk of short circuit caused by entanglement. For different installation positions, a variety of installation methods such as adhesive type, snap type, screw fixing type are also designed: the adhesive type is suitable for flat surfaces such as interior panels, and the 3M adhesive layer is sticky and lasting, and there is no residue when tearing off; the snap type is installed on a metal bracket with a light press, which is convenient to disassemble and facilitates later maintenance; the screw fixing type is used in areas with severe vibration such as the chassis to ensure foolproof positioning.
Functionally, it is not only a "fixer", but also a "protector". Its curved groove design perfectly fits with the cable outer skin, avoiding wear of the insulation layer caused by hard contact; the rounded edges are treated to prevent the cable from being scratched when shaking. Around the battery pack of new energy vehicles, the anti-corrosion positioning parts can resist electrolyte corrosion; near the transmission of traditional fuel vehicles, the high-temperature resistant model can maintain stable performance in an oil-stained environment.
Although the positioning parts of the vehicle cable clamp are small, they are related to the safety and efficiency of the vehicle circuit. It returns the messy cables to orderly, reduces the potential for failures caused by cable displacement, provides subtle but critical guarantees for the stable operation of the car, and is an indispensable "detail hero" in the automotive circuit system.
Contact Now
